Pool pump repair at a home in Oldsmar, FL
Homechevron_rightPump Repair · Oldsmar

Pool Pump Repair in Oldsmar, FL

Leaking seals, worn motors, and new variable-speed pumps, set up for Oldsmar pools.

check_circleOwner-Run Since 1995
check_circleLicensed Pool Contractor CPC1460480
check_circleRepairs Over $50 Priced First
check_circleOpen Seven Days, 9 a.m. to 9 p.m.

A drip under the pump, a puddle on the pad, or a motor that has quit? Call (727) 205-0566. A leak at the pump is worth fixing now, not later.

water_dropThe Drip

A Dripping Seal Is a Leak, and the Order Says Fix It

Among the pool rules that come with the Southwest Florida Water Management District's water shortage order, now set to run through March 31, 2027, is "the prompt repair of leaks." Most people picture a leak in the shell or the plumbing. At the equipment pad, a common one is smaller: water weeping from between the pump and the motor, where the shaft seal sits, or around a pump lid whose O-ring has flattened.

A weeping seal loses water every hour the pump runs, and the pool has to be topped off to make up for it. Left alone, it worsens, and water reaching the motor's bearings can turn a seal job into a bearing rebuild or a new motor. A seal or an O-ring is a small repair.

handyman

We fix what we can see at the pump and its plumbing. A leak somewhere in the pool's shell or underground lines is a job for a leak detection specialist we trust, and we coordinate with them.

buildSeal Repair

How a Seal Repair Goes

1
power_off

Power Off and Drained

The pump is shut off at the breaker, and the pump housing is drained.

2
build_circle

Opened Up

We separate the motor from the wet end and remove the impeller to access the seal.

3
settings

New Seal and Gaskets

Both halves of the shaft seal are replaced, along with the gaskets and O-rings we've disturbed, so nothing old is left to weep.

4
visibility

Primed and Watched

The pump is reassembled, primed, and run while we watch the joint for drips.

Tell us how long it has been dripping. A seal that has leaked for months may already have sent water to the motor's bearings, and we'll check them while it's open.

tuneProgramming

A New Motor Has to Be Set Up for Your Pool

When a motor is past saving, replacement motors made since late 2025 for full-size pumps are variable-speed, as explained on our equipment upgrades page under federal rules. If your pool still runs a single-speed pump, the replacement will be its first variable-speed motor, and that changes the job in two ways.

schedule

It Has to Be Programmed

A variable-speed motor runs on a speed schedule, not just on and off. We set it for your pool: a higher speed when the skimmers need to pull debris and the cleaner needs to run, and a lower speed for the long hours of filtration. If you have a heater, a salt system, or a feature, the schedule has to suit them too. Set wrong, a new motor can underperform the old one.

compare_arrows

It Changes the Repair-or-Replace Conversation

Because a new motor is variable-speed either way, a whole new pump is worth pricing alongside the motor swap, especially when the pump's housing, impeller, or lid has seen better days. You see both prices, and Larry tells you which he'd choose for that pad.

task_altAfter the Swap

What You'll Notice Afterward

A pool that moves from a single-speed pump to a variable-speed one behaves a little differently, and none of it means something is wrong. At its low speeds, the pump runs very quietly. It runs for more hours, at a lower speed, so the returns push more gently than you're used to. The filter pressure reads lower at low speed and climbs when the pump steps up. We'll walk you through the schedule before we leave, and show you how to change it.

waterFeature Pumps

Waterfalls, Fountains, and the Pump That Runs Them

The water shortage order limits the number of hours aesthetic fountains may run each day. The rule's own text exempts a feature that is "an integral part of the circulation system for a swimming pool." So the question on an Oldsmar pool with a waterfall or a sheer descent is which pump drives it.

water_drop

If the feature runs off the main circulation pump, it's part of the circulation system. If it has its own pump, used only for looks, it's more likely to count as an aesthetic fountain under the order. When we repair or replace either pump, we'll tell you which kind you have, so you can set its schedule accordingly. Check the current order for the exact hours before you set them.

rate_reviewWhat a Customer Said

What a Customer Said

format_quote

Above and beyond

★★★★★

“Great owner! He drove out of his way and went above and beyond to help with our pool, and we were not even current customers of his.”

Tony Kizys, Google review, July 2025
helpFAQs

Pump Questions From Oldsmar

?How Can I Tell If the Shaft Seal Is Leaking?expand_more
Look under the joint between the pump and the motor while it runs. A steady drip, a wet patch on the pad, or rust streaks on the motor end are the usual signs.
?Can a Salt System Run With a Variable-Speed Pump?expand_more
Yes, as long as the speed is high enough for the cell's flow switch to read flow. We set the schedule so the cell makes chlorine during the higher-flow hours.
?Can I Change the Pump's Schedule Myself?expand_more
Yes, from the pump's control panel, and we'll show you how. Keep the higher speed for skimming and the cleaner, and let the long filtration hours run at low speed.
?Does a Variable-Speed Pump Need an Electrician?expand_more
Not when it replaces the old pump on the same circuit. If the automation needs a new relay or the circuit needs to be changed, that part goes to an electrician we recommend.
?Can You Repair the Pump That Runs the Spa Jets?expand_more
Yes. A jet pump on an attached spa needs the same seal, bearing, and motor work as the main pump, and the same price-first approach.
exploreMore in Oldsmar

More From Dog Days in Oldsmar

What flooding does at the pad is on our pool repair in Oldsmar page, and the ways a pump fails are on our pool pump repair page. A pool that turned while the pump waited for a part needs green pool clean-up in Oldsmar; one that's only dusty or leafy needs a one-time cleaning in Oldsmar. Weekly care is on pool service in Oldsmar, and in Safety Harbor, we repair pumps too.

request_quoteFree Estimate

Drip at the Pump?

Call (727) 205-0566, seven days a week, 9 a.m. to 9 p.m. Tell us where the water is coming from, and we'll come look at the seal, the lid, and the rest of the pad.